add target SOLOGOODF405

[akarus3]

tested with X4 quad , s1,s2,s3,s4, uart1, uart2, uart3, uart4, opflow+rangefinder works good
Up: acc, gyro, baro, analog osd works too

[sensei-hacker]

Hi Akarus. Thanks for submitting this.
Are you a representative of the manufacturer?

[akarus3]

Hi Akarus. Thanks for submitting this. Are you a representative of the manufacturer?

Hi, I am a home diy. Bf can't provide opflow and rangefinder, and I build inav for my sologood f405 v1.1 with bf dump_all cli output. Now I have indor surface althold for 3.5" cinewhoop. Opflow+rangefinder is msp UpixelT1.

[sensei-hacker]

Thanks for that. I'll pull that in to my unofficial targets repository for now.
You may also want to email the manufacturer requesting that they take a look at this.

To maintain high quality for official targets, we put them through the following tests to ensure everything works correctly:

• Flash firmware
• Calibrate
• Orientation matches
• Gyro working
• Accel working
• Baro working
• Voltage correct
• Current correct
• Analog RSSI
• Mag I2C Bus
• UART1
• UART2
• UART3
• UART4
• UART5
• UART6
• LEDs working
• Buzzer working
• Motor outputs
• DShot support on m1-4
• Blackbox
• Analog Camera working
• Video Out working
• OSD working
• PINIO1
• PINIO2

The process is described in our New Hardware Policy:
https://github.com/iNavFlight/inav/blob/master/docs/policies/NEW_HARDWARE_POLICY.md

If the manufacturer sends a test board and we confirm everything works correctly, we can make it an official target.

[akarus3]

If the manufacturer sends a test board and we confirm everything works correctly, we can make it an official target.

Since we don't have a board

Am write a feedback to manufacturer, maybe it can help