Finish #584: Würth 7499010121A ethrenet magjack

[poeschlr]

This finishes the remaining points of #584
Symbol PR: KiCad/kicad-symbols#603

Datasheet http://katalog.we-online.de/pbs/datasheet/7499010121A.pdf

[Shackmeister]

Hey @poeschlr
Can you please adress the following;

• Courtyard not on grid (as travis says)

• Chamfered corner on the fab line isn't really pointing to pin 1, a triangle would probably fit better

• I think we usually only use a line to indicate pin 1 on silk, but I might be wrong

• a few silk lines are hitting the solder mask with the 0,2mm clearance

[poeschlr]

Fixed:

[Shackmeister]

@poeschlr
is it on purpose you set the pad clearance to 0,2mm? or was it only intended for checking? also should Travis accept this? Travis does actually make a warning

and if we are being extremely pedantic, this is still in the 0,2mm zone :p

[poeschlr]

I forgot to push the fix for the clearance (had it already locally. Was quite confused when i tried to fix it.)

Edit: The silk is in contact with the clearance line. for me this means it is outside the 0.2mm area (just outside) But to be honest we can not really trust kicad that much here. It approximates the clearance line using a polygon so it is not that precise.

[Shackmeister]

Might be true :) I just noticed the upper line (mirrored across X) was ending at 6,86 in order to stay totally clear, and the lower one was ending at 6,85 :)

[ghost]

I found a small issue: The two inner mechanical pins should have plated holes, so the pegs can be soldered.
Currently they are non-plated.

[poeschlr]

Are these pegs connected to the shield? Or are they only for adding mechanical strength?

[ghost]

They definitely are requited for mechanical strength.
And they are connected to the metal housing as well. So I would say yes, they are part of the shield.
That would mean the symbol needs another pin :/