Merge branch 'for-linus' of git://git.kernel.org/pub/scm/linux/kernel…

…/git/cjb/mmc

* 'for-linus' of git://git.kernel.org/pub/scm/linux/kernel/git/cjb/mmc: (75 commits)
  mmc: core: eMMC bus width may not work on all platforms
  mmc: sdhci: Auto-CMD23 fixes.
  mmc: sdhci: Auto-CMD23 support.
  mmc: core: Block CMD23 support for UHS104/SDXC cards.
  mmc: sdhci: Implement MMC_CAP_CMD23 for SDHCI.
  mmc: core: Use CMD23 for multiblock transfers when we can.
  mmc: quirks: Add/remove quirks conditional support.
  mmc: Add new VUB300 USB-to-SD/SDIO/MMC driver
  mmc: sdhci-pxa: Add quirks for DMA/ADMA to match h/w
  mmc: core: duplicated trial with same freq in mmc_rescan_try_freq()
  mmc: core: add support for eMMC Dual Data Rate
  mmc: core: eMMC signal voltage does not use CMD11
  mmc: sdhci-pxa: add platform code for UHS signaling
  mmc: sdhci: add hooks for setting UHS in platform specific code
  mmc: core: clear MMC_PM_KEEP_POWER flag on resume
  mmc: dw_mmc: fixed wrong regulator_enable in suspend/resume
  mmc: sdhi: allow powering down controller with no card inserted
  mmc: tmio: runtime suspend the controller, where possible
  mmc: sdhi: support up to 3 interrupt sources
  mmc: sdhi: print physical base address and clock rate
  ...

Documentation/ioctl/ioctl-number.txt

@@ -304,6 +304,7 @@ Code  Seq#(hex)	Include File		Comments
 0xB0	all	RATIO devices		in development:
 					<mailto:vgo@ratio.de>
 0xB1	00-1F	PPPoX			<mailto:mostrows@styx.uwaterloo.ca>
+0xB3	00	linux/mmc/ioctl.h
 0xC0	00-0F	linux/usb/iowarrior.h
 0xCB	00-1F	CBM serial IEC bus	in development:
 					<mailto:michael.klein@puffin.lb.shuttle.de>

Documentation/mmc/00-INDEX

@@ -2,3 +2,5 @@
         - this file
 mmc-dev-attrs.txt
         - info on SD and MMC device attributes
+mmc-dev-parts.txt
+        - info on SD and MMC device partitions

Documentation/mmc/mmc-dev-attrs.txt

@@ -1,3 +1,13 @@
+SD and MMC Block Device Attributes
+==================================
+
+These attributes are defined for the block devices associated with the
+SD or MMC device.
+
+The following attributes are read/write.
+
+	force_ro		Enforce read-only access even if write protect switch is off.
+
 SD and MMC Device Attributes
 ============================
 

Documentation/mmc/mmc-dev-parts.txt

@@ -0,0 +1,27 @@
+SD and MMC Device Partitions
+============================
+
+Device partitions are additional logical block devices present on the
+SD/MMC device.
+
+As of this writing, MMC boot partitions as supported and exposed as
+/dev/mmcblkXboot0 and /dev/mmcblkXboot1, where X is the index of the
+parent /dev/mmcblkX.
+
+MMC Boot Partitions
+===================
+
+Read and write access is provided to the two MMC boot partitions. Due to
+the sensitive nature of the boot partition contents, which often store
+a bootloader or bootloader configuration tables crucial to booting the
+platform, write access is disabled by default to reduce the chance of
+accidental bricking.
+
+To enable write access to /dev/mmcblkXbootY, disable the forced read-only
+access with:
+
+echo 0 > /sys/block/mmcblkXbootY/force_ro
+
+To re-enable read-only access:
+
+echo 1 > /sys/block/mmcblkXbootY/force_ro

MAINTAINERS

@@ -6800,6 +6800,13 @@ L:	lm-sensors@lm-sensors.org
 S:	Maintained
 F:	drivers/hwmon/vt8231.c
 
+VUB300 USB to SDIO/SD/MMC bridge chip
+M:	Tony Olech <tony.olech@elandigitalsystems.com>
+L:	linux-mmc@vger.kernel.org
+L:	linux-usb@vger.kernel.org
+S:	Supported
+F:	drivers/mmc/host/vub300.c
+
 W1 DALLAS'S 1-WIRE BUS
 M:	Evgeniy Polyakov <johnpol@2ka.mipt.ru>
 S:	Maintained

arch/arm/mach-tegra/include/mach/sdhci.h

@@ -24,6 +24,7 @@ struct tegra_sdhci_platform_data {
 	int wp_gpio;
 	int power_gpio;
 	int is_8bit;
+	int pm_flags;
 };
 
 #endif