- The STM32WBA-BLE-Continuous-Glucose-Monitoring demonstrating Bluetooth® SIG Continuous Glucose Monitoring Profile 1.0.2 example, based on STM32CubeWBA V1.3.1
- This example runs on STM32WBAxx devices.
- Connect the Nucleo Board to your PC with a USB cable type A to mini-B to ST-LINK connector (USB_STLINK).
-
Run this Bluetooth® Low Energy Continuous Glucose Monitoring project where the STM32WBA will advertise
-
Use the ANDROID/IOS ST BLE Sensor application or ST BLE Toolbox application to connect with this Bluetooth® Low Energy Continuous Glucose Monitoring Profile 1.0.2 (CGM_XX where XX is the 2 last digit of the Bluetooth® Device Address)
Scan on ANDROID/IOS:
After Connection, Pairing and Selecting the Continuous Glucose Monitoring Service on ANDROID/IOS you will see the following Characteristics:
For example to start a measurement session Send the Start the Session command in the CGM SPECIFIC OPS CONTROL POINT Characteristic on ANDROID/IOS:
To following measurement in the Continuous Glucose Monitoring Measurement Characteristic is shown on ANDROID/IOS:
-
Use terminal programs like Tera Term to see the logs of each board via the onboard ST-Link. (115200/8/1/n)
Caution : Issues and the pull-requests are not supported to submit problems or suggestions related to the software delivered in this repository. The STM32WBA-BLE-Continuous-Glucose-Monitoring example is being delivered as-is, and not necessarily supported by ST.
For any other question related to the product, the hardware performance or characteristics, the tools, the environment, you can submit it to the ST Community on the STM32 MCUs related page.