Ws adapter v2

[splash5]

Supporting ws adapter v2 for HW4.
Also add more cart info and showing up progress bar when reading ROM
ws_adapter_v2.zip

[Bandmo]

What are the HW pads for?

[splash5]

HW pad for selecting which HW revision you use.

[sanni]

Also remember that every PCB that goes into the SNES/NES or N64 slot will have to be ordered with 1.2mm thickness instead of the default 1.6mm or else it will not fit into the SNES slot.

[Bandmo]

Well shoot… I hope oshpark has them in the correct size. I didn’t see an option to change the thickness, only the amount of layers. I’ll check it out when they arrive. Thanks again! - Brendon

…

On Mar 5, 2022, at 5:52 AM, sanni ***@***.***> wrote:  Also remember that every PCB that goes into the SNES/NES or N64 slot will have to be ordered with 1.2mm thickness instead of the default 1.6mm or else it will not fit into the SNES slot. — Reply to this email directly, view it on GitHub, or unsubscribe. Triage notifications on the go with GitHub Mobile for iOS or Android. You are receiving this because you commented.

[sanni]

Oshpark only does 1.6mm. If you can try to cancel the order.
If the PCB is already in production you can still try it out but it will be a pretty tight fit into the SNES slot.

[Bandmo]

Done. Thanks. What about beveling? - Brendon

…

On Mar 5, 2022, at 7:03 AM, sanni ***@***.***> wrote:  Oshpark only does 1.6mm. If you can try to cancel the order. If the PCB is already in production you can still try it out but it will be a pretty tight fit into the SNES slot. — Reply to this email directly, view it on GitHub, or unsubscribe. Triage notifications on the go with GitHub Mobile for iOS or Android. You are receiving this because you commented.

[sanni]

Yes beveling is recommended for WS adapter.

[Bandmo]

I thought I canceled the order, but they showed up anyways. I tried it out, and it is a tight fit, but works. When I tried to order new pcbs through jlcpcb, the pcb had to meet a minimum size requirement in order to be beveled. I might just build a 2nd snes adaptor, and keep it as my wonderswan adaptor so I don't jack up the pins. Do you have a suggestion for another place to order the pcbs that will bevel? Thanks!

[splash5]

Hi, I recently got same problem when ordering from JLCPCB. You can try using PCBWay which they accept borad size smaller than 50mmx50mm to be beveled.

[PsyK0p4T]

I know this discussion is quite old now but @splash5 can you confirm me that your v2 adapter doesn't need the two capacitors which were on the v1 ?
Also, selecting the hw4 bridge should be fine with hw5 too right ?

I haven't builded it yet, just making a shopping-list of various pieces before starting.

[breyell]

@PsyK0p4T Just assembled one. Can confirm HW4 jumper works for HW5.

[splash5]

@PsyK0p4T Yes V2 doesn't need those two capacitors. On V1 it's just an installation option (everyone just installed them anyway).
Solder jumper HW4 means HW4 or later hardware revision (if wiring not change).

[PsyK0p4T]

Excellent, thank you guys for that reports :)
I'll maybe try to build on with a switch on the pcb, to make it compatible with every hardware version

[nsx0r]

This adapter works perfectly, thank you