Server IP problem

[Cotvi]

Hi
First of all, I would like to thank you for your work.

I have a problem with the server IP. I get IP from DHCP, but not the one I set in the configuration. In the server configuration I tried to set 192.168.201.0/24 and 192.168.201.1/24, but the visual adapter gets APIPA Autoconfiguration IPv4 Address. . : 169.254.243.145. I tried to set the address permanently, but after restarting it stops working.

If after starting I go into the network card settings wg_server and set 192.168.201.1 then ping works.

But after the server is restarted, the IP disappears.

[micahmo]

Hi @Cotvi, thanks for the report, your issue sounds very similar to this comment: #118 (comment)

Would you be able to try running these commands from an administrative PowerShell to see if it helps?

Remove-NetIPAddress -Confirm:$false -InterfaceIndex (Get-NetIPInterface -InterfaceAlias wg_server)[0].ifIndex
New-NetIPAddress -IPAddress 192.168.201.1 -PrefixLength 24 -InterfaceIndex (Get-NetIPInterface -InterfaceAlias wg_server)[0].ifIndex

[Cotvi]

Yes. That helps.

Unfortunately, after restarting, DHCP is still enabled.

When I run the script again, I get the correct IP.

Is that how I should solve this problem by setting a schedule?

[micahmo]

Do you have the Automatic NAT Routing enabled? If so, have you tried setting a Boot Task Delay? (Note that if you enable a Boot Task Delay, you have to disable and then re-enable the Automatic NAT Routing.) Try playing around with that. It's supposed to apply those same commands from above after you boot up.

If that doesn't help, you might have to make your own Scheduled Task to do the same thing.

[Cotvi]

Hi. I don't have NAT enabled because I only need to access this computer.

I'll make a schedule with a task then.

Thank you.