T-Beam board (repater) - no GPS support

[samm-git]

This is from serial with debug enabled:

rst:0x1 (POWERON_RESET),boot:0x13 (SPI_FAST_FLASH_BOOT)
configsip: 0, SPIWP:0xee
clk_drv:0x00,q_drv:0x00,d_drv:0x00,cs0_drv:0x00,hd_drv:0x00,wp_drv:0x00
mode:DIO, clock div:2
load:0x3fff0030,len:1184
load:0x40078000,len:13232
load:0x40080400,len:3028
entry 0x400805e4
DEBUG: AXP2101 PMU init succeeded, using AXP2101 PMU
                                                    Scanning I2C for Devices
	Found AXP192/AXP2101 PMU
	Found SSD1306/SH1106 display
Scan for devices is complete.


GPS RX pin: 12 GPS TX pin: 34
isCharging:NO
isDischarge:NO
isVbusIn:YES
getBattVoltage:4175mV
getVbusVoltage:5219mV
getSystemVoltage:5222mV
getBatteryPercent:100%

Repeater ID: XXXXX
DEBUG: No GPS wake/reset pin found for this board. Continuing on...
                                                                   DEBUG: GPS detected
                                                                                      DEBUG: Start GPS is N/A on this board. Actual GPS state unchanged
                                                                                                                                                       DEBUG: RadioLibWrap

And it's never getting fixed and probably not working at all:

gps
  -> on, active, no fix, 0 sats

[samm-git]

I just had to wait longer, for whatever reason it got fix in about a day after setup and now work fine.