ESP32_SPS30_DashBoard

ESP32 with sensors SPS30, BME680 and OLED SSH1106 output + DashBoard WebServer + Logging to ThingSpeak

Required Arduino Libraries

• Add Arduino_ESP32_SPS30 library to arduino/libraries/
• via Arduino Library Manager:
  • Adafruit Unified Sensors
  • Adafruit BME680
  • u8g2
• via Arduino Board Manager
  • ESP32

Hardware / Pins

• SPS30 - pins 16 , 17 ( 5V , GND )
  • UART TX -> IO #16
  • UART RX -> IO #17
  • 5V
  • GND
• SSH1106 - pins:
  • GND
  • 5V (VCC)
  • CLK -> IO #18
    • Clock
  • MOSI -> IO #23
    • Master Out Slave In (the data line).
  • RES -> IO #32
    • This is not actually an SPI Pin and can be set to any pin.
    • Reset
  • DC -> IO #33
    • This is not actually an SPI Pin and can be set to any pin.
    • Data Command
  • CS -> IO #5
    • This is not actually an SPI Pin and can be set to any pin.
    • Cable Select
• BME680
  • 21
  • 22
  • 3V
  • GND

Terms

PM = Particle Mass (μg/m³)(micrograms per cubic meter)

NC = Number Concentration (#/cm³)(count per cubic centimeter)

Science and Guidelines on Air Quality

The World Health Organization recommends limiting particulate matter to the following values:

• Annual average PM10 20 µg/m³
• Annual average PM2.5 10 µg/m³ per year
• Daily average PM10 50 µg/m³ without permitted days on which exceeding is possible.
• Daily average PM2.5 25 µg/m³ without permitted days on which exceeding is possible

see also: Air Quality Index

• https://www.who.int/airpollution/infographics/en/
• https://www.who.int/airpollution/en/