Releases: drunken-octopus/drunken-octopus-marlin
Drunken Octopus February Release 29
This is the release for February, with the following changes:
- New code from upstream
- Added new builds:
- TAZ6 Archim Aerostruder V2 (CecropiaSilk)
- TAZ6 Archim E3D Hermera
Drunken Octopus January Release 28
This is a revised release for January, with the following changes:
- For the YellowFin Dual Extruder on Archim, correct fan pin out.
Drunken Octopus January Release 27
This is a revised release for January, with the following changes:
- For the YellowFin Dual Extruder on Archim, also swap the heaters in addition to the motors.
Drunken Octopus January Release 26
- Merged in new code from upstream.
- Swapped extruders and extruder fan pins on the YellowFin Dual when compiling for the Archim board (just as it is done for the Rambo board)
UPDATE: This release is does not swap the heaters on the YellowFin Dual, making it non-usable. Please use release 27 instead.
Drunken Octopus December Release 25
- Merged in new code from upstream.
- In the previous release, the binaries with BLTouch were to large to be uploaded to the Rambo board. This release removes the easter egg games and G26 mesh validation from these builds to allow the firmware to fit on the Rambo board.
- On user request, this release adds an untested and experimental TAZ 6 + Archim + BLTouch firmware for the M175 toolhead.
Drunken Octopus October Release 24
- New code from upstream Marlin
- Added additional builds:
- TAZ6 w/ Archim, Dual Extruder v3 (Yellowfin)
- TAZ6 w/ Archim, FlexyDually (Longfin)
Drunken Octopus September - Testing Release 23
In release 22, the following two problems have been reported:
- On LulzBot profiles, a G26 that is present in start GCODE could cause Marlin to print a test pattern
- One user has reported board restarts and freezes, including a thermal runaway
This release adds a guard to prevent G26 from printing a test pattern when the print timer is executing (i.e. after a M75) which should prevent the problem with the standard start GCODE.
It is unclear whether the second freezing issue was a fluke or has anything to do with the the addition of G26, so I am including two testing releases, one with G26 enabled, one without and am inviting anyone who is able to test it out.
If you have comments on this release, please create a GitHub issue.
Drunken Octopus September Release 22
This is the September release. It looks like it is causing problems for some users. I recommend sticking to rc21 unless you want to help troubleshoot.
Drunken Octopus August Release 21
v2.0.0.1rc21 Added ESP3D to Mini boards
Drunken Octopus August Release 20
v2.0.0.1rc20 Added Guava_TAZ4BLTouch