A set of scripts changing the SN and unlocking the Region of Ninebot MAX G3.
🛠️ Ninebot Max G3 Unlock & Cruise Control Activation Guide
🔧 What You Need Ninebot Max G3 (with stock dashboard)
ST-Link V2 programmer
Dupont cables (female-Male)
Windows or linux/mac PC (i tested it only on windows)
g3Scripts latest (ST-Link firmware tools)
Small screwdriver set (Torx or Allen and philips)
Time and patience
📋 Instructions
-
Unbind Scooter from Ninebot App Before flashing, go into the Ninebot app and remove your G3 from your account.
-
Remove Dashboard Power off your scooter completely.
Use a screwdriver to remove the dashboard panel.
Carefully disconnect the cable from the dashboard.
- Connect ST-Link to the VCU Open the deck of the scooter to access the VCU (Vehicle Control Unit).
Identify the SWD connection pads:
SWDIO
SWCLK
GND
3.3V (power, required for ST-Link)
Connect the ST-Link V2 programmer using Dupont wires:
ST-Link SWDIO → VCU SWDIO
ST-Link SWCLK → VCU SWCLK
ST-Link GND → VCU GND
(required) ST-Link 3.3V → VCU 3.3V
IMPORTANT : the C45 Cpacitor on the board needs to be shorted during the whole read and write process.
- Backup Original Firmware Connect the ST-Link to your PC.
Download and extract the Max G3 latest script package.
Run the following batch files in order:
dump_ram.bat
dump_memory.bat
This will generate:
RAM_G3_dumped.bin
MEMORY_G3.bin
Back these up safely. You’ll need them to restore your scooter.
- Change Region for Speed Unlock Run change_sn.bat
Choose the region code:
C = USA (40 km/h)
B = Germany (20 km/h)
A new file MEMORY_G3_modded.bin will be created.
- Flash the Modified Firmware Run flash_memory_modded.bat
Wait for it to erase and write the memory. This takes a few seconds.
- Reassemble and Rebind Disconnect the ST-Link.
Reconnect and reinstall the dashboard.
Open the Ninebot app and rebind your G3.
((if you get the error that the serial number is bound to another account you need to manually edit the dump using a hex editor and change to another serial number.
You should now see an increased speed limit and cruise control option.
🔁 Restore to Stock (If Needed) If you want to return to the original firmware:
Disconnect from the app.
Connect ST-Link to the VCU.
Run flash_memory_og.bat
Reassemble and rebind.
🚀 Using Cruise Control To activate cruise control while riding:
Reach your desired speed.
Hold the mode button for 3+ seconds until you hear a beep.
Release the throttle. The scooter will maintain speed.
❗ Troubleshooting Nothing happens when running scripts → Check ST-Link drivers.
Error during flash → Check wire connections and power.
Speed didn’t change → Make sure you selected C region and rebooted the scooter.
App won’t bind → Reset Bluetooth and scooter before trying again.
This process is for advanced users and may require several attempts if connections are unstable. If you need community support, look for Ninebot Max G3 modding forums or Telegram groups related to G30/G3 firmware.
Based on: