ONVIF Profile S camera adapter for WebThings Gateway.
NOTE: Things will be much more painless if your cameras are all given static IP addresses on your network.
- Foscam R2
- SV3C SV-B06W-1080P-HX
- Amcrest IP3M-941B
All other ONVIF Profile S compatible cameras.
This add-on can be installed through the UI, via Settings -> Add-ons -> +.
NOTE: If you are installing this add-on in a gateway you built yourself, your system will need to have ffmpeg installed.
When new devices are detected, they are added to the add-on's config with a blank username/password entry. Therefore, to configure each device, do the following:
- Start a search for new devices from the Things screen.
- After the search has completed, navigate to Settings -> Add-ons.
- Click on the Configure button for the ONVIF add-on.
- Any new devices should be auto-populated in the devices list. Fill in the username and password for each as required.
- Click Apply.
- After a few seconds, go back to the Things screen and start a new search again.
- If everything went well, your devices should now be available.
Additionally, PTZ controls can be optionally enabled.
If your devices were not auto-populated in the configuration screen, but you know the address of the cameras, you can configure them as follows:
- Launch the config editor by navigating to Settings -> Add-ons and clicking the Configure button for the ONVIF add-on.
- Add a new entry for your device by clicking + and filling in the fields.
- Click Apply.
- After a few seconds, go back to the Things screen and start a new search again.
- If everything went well, your devices should now be available.