Conectric EKM Configuration Tool

This tool allows you to configure properties of EKM meters that are connected to a Conectric mesh network using Conectric's RS-485 devices.

At the moment the following functionality is supported:

• Set CT Ratio.

Setup

This tool requires Node.js 8.9.4 or newer. To install dependencies:

$ npm install

Configuration File

This tool reads a JSON file to configure meters. When using this tool with Conectric's gateway, you should setup the meter configurations that you require in the gateway's meters.json file (read documentation).

Configuring Meter CT Ratios

Once you have configured the meters.json file, run the tool to set the meter CT ratios as follows (if you are using this tool on the Conectric Gateway then you will need to stop the gateway service first):

$ npm run setct </path/to>/meters.json

The tool will loop over each meter that has a CT ratio set in the meters.json file, and send the appropriate configuration commands to the meter.

If you are using this tool on the Conectric Gateway then you will need to restart the gateway service now.