Improved Confirmation Box for Raw Parameter Setup

[prathamEndu]

Issue Details

Enhancement Proposal: Improved Confirmation Box for Raw Parameter Setup

When changing parameters and writing them, the current implementation displays a confirmation dialog box. However, I propose an enhancement to this dialog: it should list all changed parameters, showing both their previous and new values. This would allow users to verify all changes before confirming.

Implementation

I am interested in working on this enhancement myself, if possible. I believe the relevant code may reside in the GCSViews/ConfigurationView/ConfigRawParams.cs file, but I’m not entirely certain.

Any suggestions or guidance on where to start would be greatly appreciated.

[prathamEndu]

I’ve submitted a pull request to address the issue Enhance full parameter change message box #3412. This PR improves the confirmation dialog by displaying all changed parameters along with their previous and new values, enhancing user verification before finalizing changes.

Here is a preview :

[jagrandle]

In your proposal above you said "This would allow users to verify all changes before confirming."

However you only receive this message AFTER you have made the changes. Might it not be a bit superfluous by then ?

[prathamEndu]

Good point, I have made another commit with added changes in the same PR

The following changed are done in the final commit

In a separate confirmation box for parameter changes :

1. 0 parameter changes are ignored
2. 1-20 parameter changes are shown with details (a separate loop is run for collecting these details)
3. more than 20 parameter changes are shown just as a number

In the saved parameter box :

1. 0 parameter change message updated
2. more than 0 parameter change show the count

Preview

Fig : existing message box

Fig : less than or equal to 20 changes confirmation box

Fig : more than 20 changes confirmation box

Fig : no param change saved box

Fig : one or more param change saved box