gpio-lynxpoint: enable input sensing in resume

It appears that input sensing bit might be reset during
suspend/resume. Set input sensing again for all requested gpios
in resume

Tested-by: Jerome Blin <jerome.blin@intel.com>
Signed-off-by: Mathias Nyman <mathias.nyman@linux.intel.com>
Acked-by: Mika Westerberg <mika.westerberg@linux.intel.com>
Signed-off-by: Linus Walleij <linus.walleij@linaro.org>

drivers/gpio/gpio-lynxpoint.c

@@ -407,9 +407,27 @@ static int lp_gpio_runtime_resume(struct device *dev)
 	return 0;
 }
 
+static int lp_gpio_resume(struct device *dev)
+{
+	struct platform_device *pdev = to_platform_device(dev);
+	struct lp_gpio *lg = platform_get_drvdata(pdev);
+	unsigned long reg;
+	int i;
+
+	/* on some hardware suspend clears input sensing, re-enable it here */
+	for (i = 0; i < lg->chip.ngpio; i++) {
+		if (gpiochip_is_requested(&lg->chip, i) != NULL) {
+			reg = lp_gpio_reg(&lg->chip, i, LP_CONFIG2);
+			outl(inl(reg) & ~GPINDIS_BIT, reg);
+		}
+	}
+	return 0;
+}
+
 static const struct dev_pm_ops lp_gpio_pm_ops = {
 	.runtime_suspend = lp_gpio_runtime_suspend,
 	.runtime_resume = lp_gpio_runtime_resume,
+	.resume = lp_gpio_resume,
 };
 
 static const struct acpi_device_id lynxpoint_gpio_acpi_match[] = {