This is a spin-off from the original Home Assistant integration which was deprecated and was removed in Home Assistant Core v2022.4.
The rpi_rf switch platform allows you to control devices over 433/315MHz LPD/SRD signals with generic low-cost GPIO RF modules on a Raspberry Pi.
Interoperable with codes sniffed via the rpi-rf module or rc-switch. For more info see the PyPi module description: rpi-rf.
The recommended way to install rpi_rf is through HACS.
Copy the rpi_rf folder and all of its contents into your Home Assistant's custom_components folder. This folder is usually inside your /config folder. If you are running Hass.io, use SAMBA to copy the folder over. You may need to create the custom_components folder and then copy the rpi_rf folder and all of its contents into it.
To enable, add the following to your configuration.yaml:
# Example configuration.yaml entry
switch:
- platform: rpi_rf
gpio: 17
switches:
bedroom_light:
code_on: 1234567
code_off: 1234568
ambilight:
pulselength: 200
code_on: 987654
code_off: 133742
length: 24
living_room_light:
protocol: 5
code_on: 654321,565874,233555,149874
code_off: 654320,565873,233554,149873
signal_repetitions: 15| Key | Required | Default | Type | Description |
|---|---|---|---|---|
gpio |
yes | integer | GPIO to which the data line of the TX module is connected. | |
switches |
yes | list | The array that contains all switches. | |
entry |
yes | list | Name of the switch. Multiple entries are possible. | |
code_on |
yes | list | Decimal code(s) to switch the device on. To run multiple codes in a sequence, separate the individual codes with commas ‘,’. | |
code_off |
yes | list | Decimal code(s) to switch the device off. To run multiple codes in a sequence, separate the individual codes with commas ‘,’. | |
protocol |
no | 1 |
integer | RF Protocol. |
pulselength |
no | integer | Pulselength. | |
signal_repetitions |
no | 10 |
integer | Number of times to repeat transmission. |
length |
no | 24 |
integer | Code Length |