Replies: 4 comments 2 replies
-
|
Thank your for submiting, please be sure you followed template or your issue may be dismissed. if you deleted the template it is here |
Beta Was this translation helpful? Give feedback.
-
|
if your ESP is connected to TFT Marlin does not need any configuration unless your TFT has no FW , but in that case you need to check the pinout of Serial and what serial is related in Marlin And also be sure baude rate is same between ESP and Marlin |
Beta Was this translation helpful? Give feedback.
-
|
I see here : So if it is BTT TFT35 you need to configure your TFT to bridge the Serial from ESP to Printer - I think there is an ini file - and need to check what is FW version |
Beta Was this translation helpful? Give feedback.
-
|
It is really a SKR V1.4 Mainboard/BTT TFT35 V3.0. I am really not understanding the problem, because I am not able to find any "bridge" option in config.ini file. ESP port has already my ESP01 connected and accessible. |
Beta Was this translation helpful? Give feedback.
-
|
you just need to read the config.ini carrefuly, it explain how to configure it for the wifi port on tft and once modified, copy it to your tft sd and restart the tft, |
Beta Was this translation helpful? Give feedback.
-
|
Thanks... found the problem. Original config.ini was: It should be: |
Beta Was this translation helpful? Give feedback.
-
I have a Biqu B1 and my ESP01 is connected to serial located in its TFT display.
Anybody knows if I need to enable any specific port in Marlin to ESP01 communicate with the printer?
ESP01 is starting up and I am able to connect the website, but ESP3D do not find any printer, and the printer do not find the ESP3D.
Thanks!
Beta Was this translation helpful? Give feedback.
All reactions