Replies: 9 comments 13 replies
-
what name did you use? |
Beta Was this translation helpful? Give feedback.
-
UI: 2.1.1 / FW: 2.1.0.c26 using Esp-01s on TFT35 |
Beta Was this translation helpful? Give feedback.
-
eample name "kup.gco" |
Beta Was this translation helpful? Give feedback.
-
tft firmware "BIGTREE_TFT35_V3.0_E3.27.x.bin" latest one |
Beta Was this translation helpful? Give feedback.
-
I used his repositories but nothing change still same |
Beta Was this translation helpful? Give feedback.
-
I think it's a connection error due to wifi. TFT fw was ok |
Beta Was this translation helpful? Give feedback.
-
Thanks will try |
Beta Was this translation helpful? Give feedback.
-
8 kb gco file but same transfer starts showing as "%". Even if it says "100%", it gives an error after a while. "no connection" on TFT "sd upload failed" |
Beta Was this translation helpful? Give feedback.
-
I can upload any file to sd card (on skr mini e3 v3) via Octoprint |
Beta Was this translation helpful? Give feedback.
-
when i want to upload I get this error.
Change file name to short one and extension "*.gco"
start upload but cant finish
see uploading ****.gco %100
but then
Error
No connection
Beta Was this translation helpful? Give feedback.
All reactions