this router use a very simple tech by using phase differences. The project can reproduce easily for the electronic board. however I made an industrial version of it to make things easier. The board was sold by a French Association ( APPER )
You only need to by separatly :
. A TTGO-Tdisplay
. A SCT-013-30
. And an 12V - AC power supply ( Sinus ) you can made it with a modified old 12DC coil transformer. ( see below )
For packaging, I use the box that comes with the TTGO.
rename the file wifi.json.ori to wifi.json and change SID
if you know your configuration you can change it on config.json
Upload the firmware and filesystem. the system will start and working
You can use OTA upload by the web page /update Build firmware of filesystem with VS and upload the .bin
connections :
OLED :
3.3V
GND
21 SCL
22 SDA
SCT013 wbr
div bridge R/R between 3.3V and GND
SCT013 connected at the middle of div bridge and pin 34 ( --> Linky )
condensator 470uf between GND and the middle of div bridge. ( filter )
pin 32 GRID
pin 33 SCT013
The carrier is made with a 12v transformer power supply. The bridge rectifier is removed and the wavy part is kept There is a divider bridge not to exceed 3.3V and a diode for half alternation.
The assembly as a whole will raise the power and the direction of the current. Like the ESP8266 version, it can connect directly to the Wifi dimmer to control the power. github Project
Open the transformer and remove the diode bridge
Close the transformer and verify the voltage. ~12V AC ( 9-16v ) and adjust the divider bridge if needed ( output 3.3V max )