forked from microsoft/WSL2-Linux-Kernel
-
Notifications
You must be signed in to change notification settings - Fork 0
/
Copy pathti_usb_3410_5052.h
225 lines (196 loc) · 5.87 KB
/
ti_usb_3410_5052.h
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
57
58
59
60
61
62
63
64
65
66
67
68
69
70
71
72
73
74
75
76
77
78
79
80
81
82
83
84
85
86
87
88
89
90
91
92
93
94
95
96
97
98
99
100
101
102
103
104
105
106
107
108
109
110
111
112
113
114
115
116
117
118
119
120
121
122
123
124
125
126
127
128
129
130
131
132
133
134
135
136
137
138
139
140
141
142
143
144
145
146
147
148
149
150
151
152
153
154
155
156
157
158
159
160
161
162
163
164
165
166
167
168
169
170
171
172
173
174
175
176
177
178
179
180
181
182
183
184
185
186
187
188
189
190
191
192
193
194
195
196
197
198
199
200
201
202
203
204
205
206
207
208
209
210
211
212
213
214
215
216
217
218
219
220
221
222
223
224
225
/* vi: ts=8 sw=8
*
* TI 3410/5052 USB Serial Driver Header
*
* Copyright (C) 2004 Texas Instruments
*
* This driver is based on the Linux io_ti driver, which is
* Copyright (C) 2000-2002 Inside Out Networks
* Copyright (C) 2001-2002 Greg Kroah-Hartman
*
* This program is free software; you can redistribute it and/or modify
* it under the terms of the GNU General Public License as published by
* the Free Software Foundation; either version 2 of the License, or
* (at your option) any later version.
*
* For questions or problems with this driver, contact Texas Instruments
* technical support, or Al Borchers <alborchers@steinerpoint.com>, or
* Peter Berger <pberger@brimson.com>.
*/
#ifndef _TI_3410_5052_H_
#define _TI_3410_5052_H_
/* Configuration ids */
#define TI_BOOT_CONFIG 1
#define TI_ACTIVE_CONFIG 2
/* Vendor and product ids */
#define TI_VENDOR_ID 0x0451
#define TI_3410_PRODUCT_ID 0x3410
#define TI_3410_EZ430_ID 0xF430 /* TI ez430 development tool */
#define TI_5052_BOOT_PRODUCT_ID 0x5052 /* no EEPROM, no firmware */
#define TI_5152_BOOT_PRODUCT_ID 0x5152 /* no EEPROM, no firmware */
#define TI_5052_EEPROM_PRODUCT_ID 0x505A /* EEPROM, no firmware */
#define TI_5052_FIRMWARE_PRODUCT_ID 0x505F /* firmware is running */
/* Commands */
#define TI_GET_VERSION 0x01
#define TI_GET_PORT_STATUS 0x02
#define TI_GET_PORT_DEV_INFO 0x03
#define TI_GET_CONFIG 0x04
#define TI_SET_CONFIG 0x05
#define TI_OPEN_PORT 0x06
#define TI_CLOSE_PORT 0x07
#define TI_START_PORT 0x08
#define TI_STOP_PORT 0x09
#define TI_TEST_PORT 0x0A
#define TI_PURGE_PORT 0x0B
#define TI_RESET_EXT_DEVICE 0x0C
#define TI_WRITE_DATA 0x80
#define TI_READ_DATA 0x81
#define TI_REQ_TYPE_CLASS 0x82
/* Module identifiers */
#define TI_I2C_PORT 0x01
#define TI_IEEE1284_PORT 0x02
#define TI_UART1_PORT 0x03
#define TI_UART2_PORT 0x04
#define TI_RAM_PORT 0x05
/* Modem status */
#define TI_MSR_DELTA_CTS 0x01
#define TI_MSR_DELTA_DSR 0x02
#define TI_MSR_DELTA_RI 0x04
#define TI_MSR_DELTA_CD 0x08
#define TI_MSR_CTS 0x10
#define TI_MSR_DSR 0x20
#define TI_MSR_RI 0x40
#define TI_MSR_CD 0x80
#define TI_MSR_DELTA_MASK 0x0F
#define TI_MSR_MASK 0xF0
/* Line status */
#define TI_LSR_OVERRUN_ERROR 0x01
#define TI_LSR_PARITY_ERROR 0x02
#define TI_LSR_FRAMING_ERROR 0x04
#define TI_LSR_BREAK 0x08
#define TI_LSR_ERROR 0x0F
#define TI_LSR_RX_FULL 0x10
#define TI_LSR_TX_EMPTY 0x20
/* Line control */
#define TI_LCR_BREAK 0x40
/* Modem control */
#define TI_MCR_LOOP 0x04
#define TI_MCR_DTR 0x10
#define TI_MCR_RTS 0x20
/* Mask settings */
#define TI_UART_ENABLE_RTS_IN 0x0001
#define TI_UART_DISABLE_RTS 0x0002
#define TI_UART_ENABLE_PARITY_CHECKING 0x0008
#define TI_UART_ENABLE_DSR_OUT 0x0010
#define TI_UART_ENABLE_CTS_OUT 0x0020
#define TI_UART_ENABLE_X_OUT 0x0040
#define TI_UART_ENABLE_XA_OUT 0x0080
#define TI_UART_ENABLE_X_IN 0x0100
#define TI_UART_ENABLE_DTR_IN 0x0800
#define TI_UART_DISABLE_DTR 0x1000
#define TI_UART_ENABLE_MS_INTS 0x2000
#define TI_UART_ENABLE_AUTO_START_DMA 0x4000
/* Parity */
#define TI_UART_NO_PARITY 0x00
#define TI_UART_ODD_PARITY 0x01
#define TI_UART_EVEN_PARITY 0x02
#define TI_UART_MARK_PARITY 0x03
#define TI_UART_SPACE_PARITY 0x04
/* Stop bits */
#define TI_UART_1_STOP_BITS 0x00
#define TI_UART_1_5_STOP_BITS 0x01
#define TI_UART_2_STOP_BITS 0x02
/* Bits per character */
#define TI_UART_5_DATA_BITS 0x00
#define TI_UART_6_DATA_BITS 0x01
#define TI_UART_7_DATA_BITS 0x02
#define TI_UART_8_DATA_BITS 0x03
/* 232/485 modes */
#define TI_UART_232 0x00
#define TI_UART_485_RECEIVER_DISABLED 0x01
#define TI_UART_485_RECEIVER_ENABLED 0x02
/* Pipe transfer mode and timeout */
#define TI_PIPE_MODE_CONTINOUS 0x01
#define TI_PIPE_MODE_MASK 0x03
#define TI_PIPE_TIMEOUT_MASK 0x7C
#define TI_PIPE_TIMEOUT_ENABLE 0x80
/* Config struct */
struct ti_uart_config {
__u16 wBaudRate;
__u16 wFlags;
__u8 bDataBits;
__u8 bParity;
__u8 bStopBits;
char cXon;
char cXoff;
__u8 bUartMode;
} __attribute__((packed));
/* Get port status */
struct ti_port_status {
__u8 bCmdCode;
__u8 bModuleId;
__u8 bErrorCode;
__u8 bMSR;
__u8 bLSR;
} __attribute__((packed));
/* Purge modes */
#define TI_PURGE_OUTPUT 0x00
#define TI_PURGE_INPUT 0x80
/* Read/Write data */
#define TI_RW_DATA_ADDR_SFR 0x10
#define TI_RW_DATA_ADDR_IDATA 0x20
#define TI_RW_DATA_ADDR_XDATA 0x30
#define TI_RW_DATA_ADDR_CODE 0x40
#define TI_RW_DATA_ADDR_GPIO 0x50
#define TI_RW_DATA_ADDR_I2C 0x60
#define TI_RW_DATA_ADDR_FLASH 0x70
#define TI_RW_DATA_ADDR_DSP 0x80
#define TI_RW_DATA_UNSPECIFIED 0x00
#define TI_RW_DATA_BYTE 0x01
#define TI_RW_DATA_WORD 0x02
#define TI_RW_DATA_DOUBLE_WORD 0x04
struct ti_write_data_bytes {
__u8 bAddrType;
__u8 bDataType;
__u8 bDataCounter;
__be16 wBaseAddrHi;
__be16 wBaseAddrLo;
__u8 bData[0];
} __attribute__((packed));
struct ti_read_data_request {
__u8 bAddrType;
__u8 bDataType;
__u8 bDataCounter;
__be16 wBaseAddrHi;
__be16 wBaseAddrLo;
} __attribute__((packed));
struct ti_read_data_bytes {
__u8 bCmdCode;
__u8 bModuleId;
__u8 bErrorCode;
__u8 bData[0];
} __attribute__((packed));
/* Interrupt struct */
struct ti_interrupt {
__u8 bICode;
__u8 bIInfo;
} __attribute__((packed));
/* Interrupt codes */
#define TI_GET_PORT_FROM_CODE(c) (((c) >> 4) - 3)
#define TI_GET_FUNC_FROM_CODE(c) ((c) & 0x0f)
#define TI_CODE_HARDWARE_ERROR 0xFF
#define TI_CODE_DATA_ERROR 0x03
#define TI_CODE_MODEM_STATUS 0x04
/* Download firmware max packet size */
#define TI_DOWNLOAD_MAX_PACKET_SIZE 64
/* Firmware image header */
struct ti_firmware_header {
__le16 wLength;
__u8 bCheckSum;
} __attribute__((packed));
/* UART addresses */
#define TI_UART1_BASE_ADDR 0xFFA0 /* UART 1 base address */
#define TI_UART2_BASE_ADDR 0xFFB0 /* UART 2 base address */
#define TI_UART_OFFSET_LCR 0x0002 /* UART MCR register offset */
#define TI_UART_OFFSET_MCR 0x0004 /* UART MCR register offset */
#endif /* _TI_3410_5052_H_ */