MediaTek firmware dumper for Linux

Currently only for MT6260/MT6261 chipset. You can edit the code to work with other MediaTek chipsets.

• THE SOFTWARE IS PROVIDED "AS IS", WITHOUT WARRANTY OF ANY KIND, USE AT YOUR OWN RISK!

Build

There are two options:

1. Using libusb for Linux and Windows (MSYS2):
   Use make, libusb/libusb-dev packages must be installed.

• For Windows users - please read how to install a driver for libusb.

2. Using the USB serial, Linux only and doesn't work with smartphones:
   Use make LIBUSB=0. If you're using this mode, you must initialize the USB serial driver before using the tool (every boot):

$ sudo modprobe ftdi_sio
$ echo 0e8d 0003 | sudo tee /sys/bus/usb-serial/drivers/generic/new_id

• On Linux you must run the tool with sudo, unless you are using special udev rules (see below).

Instructions

Run this command and connect your device to USB:

$ sudo ./mtk_dump connect  show_flash 1  read32 0 0x400000 dump.bin

• Where 0x400000 (4MB) is the expected length of flash in bytes (may be more or less).
• An example payload is here (you can read the BROM with it).

Using the tool without sudo

If you create /etc/udev/rules.d/80-spd-mtk.rules with these lines:

# Spreadtrum
SUBSYSTEMS=="usb", ATTRS{idVendor}=="1782", ATTRS{idProduct}=="4d00", MODE="0666", TAG+="uaccess"
# MediaTek
SUBSYSTEMS=="usb", ATTRS{idVendor}=="0e8d", ATTRS{idProduct}=="0003", MODE="0666", TAG+="uaccess"

...then you can run mtk_dump without root privileges.

• As you can see this file for both Spreadtrum and MediaTek chipsets.

Using libusb to connect

You can build the tool with libusb method: make LIBUSB=1

For Linux users, this method doesn't require the ftdi_sio kernel module, but libusb/libusb-dev packages must be installed.

For Windows users, this method is the only one available, should also require drivers (the same as needed for flashing tools).

Useful links

1. Fernly - some of the MT6260 reversed
2. MTKClient - tools for many MTK chipsets (in Python)
3. decompressor for ALICE chunks in the firmware (in Python)

• Also I have the tool for Spreadtrum chipsets.