Enable HAL MDMA by default

Some series require to have it defined by default (H7, MP1)

Signed-off-by: Frederic Pillon <frederic.pillon@st.com>

Author: fpistm

cores/arduino/stm32/stm32yyxx_hal_conf.h

@@ -11,6 +11,7 @@
 #define HAL_GPIO_MODULE_ENABLED
 #define HAL_HSEM_MODULE_ENABLED
 #define HAL_IPCC_MODULE_ENABLED
+#define HAL_MDMA_MODULE_ENABLED /* Required by HAL QSPI module */
 #define HAL_PWR_MODULE_ENABLED
 #define HAL_RCC_MODULE_ENABLED
 

system/STM32MP1xx/stm32mp1xx_hal_conf_default.h

@@ -40,7 +40,6 @@
 #define HAL_RTC_MODULE_DISABLED /* RTC MODULE on Cortex-M side is not supported.
                                    Linux on Cortex-A will handle this. */
 #define HAL_ETH_MODULE_DISABLED /* ETH module is also not intended to be used */
-#define HAL_MDMA_MODULE_ENABLED /* Some other modules (e.g. USART) require this */
 
 #if defined(ARDUINO_STM32MP157A_DK1) || defined(ARDUINO_STM32MP157C_DK2)
 // Cannot use them in this board, or define them in the kernel device tree.