net: phy: at803x: mask 1000 Base-X link mode

AR8031/AR8033 have different status registers for copper
and fiber operation. However, the extended status register
is the same for both operation modes.

As a result of that, ESTATUS_1000_XFULL is set to 1 even when
operating in copper TP mode.

Remove this mode from the supported link modes, as this driver
currently only supports copper operation.

Signed-off-by: David Bauer <mail@david-bauer.net>
Reviewed-by: Andrew Lunn <andrew@lunn.ch>
Signed-off-by: David S. Miller <davem@davemloft.net>

Author: blocktrron

drivers/net/phy/at803x.c

@@ -610,6 +610,34 @@ static void at803x_remove(struct phy_device *phydev)
 		regulator_disable(priv->vddio);
 }
 
+static int at803x_get_features(struct phy_device *phydev)
+{
+	int err;
+
+	err = genphy_read_abilities(phydev);
+	if (err)
+		return err;
+
+	if (!at803x_match_phy_id(phydev, ATH8031_PHY_ID))
+		return 0;
+
+	/* AR8031/AR8033 have different status registers
+	 * for copper and fiber operation. However, the
+	 * extended status register is the same for both
+	 * operation modes.
+	 *
+	 * As a result of that, ESTATUS_1000_XFULL is set
+	 * to 1 even when operating in copper TP mode.
+	 *
+	 * Remove this mode from the supported link modes,
+	 * as this driver currently only supports copper
+	 * operation.
+	 */
+	linkmode_clear_bit(ETHTOOL_LINK_MODE_1000baseX_Full_BIT,
+			   phydev->supported);
+	return 0;
+}
+
 static int at803x_smarteee_config(struct phy_device *phydev)
 {
 	struct at803x_priv *priv = phydev->priv;
@@ -1225,7 +1253,7 @@ static struct phy_driver at803x_driver[] = {
 	.resume			= at803x_resume,
 	.read_page		= at803x_read_page,
 	.write_page		= at803x_write_page,
-	/* PHY_GBIT_FEATURES */
+	.get_features		= at803x_get_features,
 	.read_status		= at803x_read_status,
 	.config_intr		= &at803x_config_intr,
 	.handle_interrupt	= at803x_handle_interrupt,