Merge pull request #8 from frank-w/4.16-main

4.16 main

Author: d3adme4t

.gitignore

@@ -131,3 +131,8 @@ all.config
 #Automatically generated by ASN.1 compiler
 net/ipv4/netfilter/nf_nat_snmp_basic-asn1.c
 net/ipv4/netfilter/nf_nat_snmp_basic-asn1.h
+
+#own
+arch/arm/boot/zImage-dtb
+uImage
+uboot/

Documentation/devicetree/bindings/display/panel/panel-common.txt

@@ -38,7 +38,7 @@ Display Timings
   require specific display timings. The panel-timing subnode expresses those
   timings as specified in the timing subnode section of the display timing
   bindings defined in
-  Documentation/devicetree/bindings/display/display-timing.txt.
+  Documentation/devicetree/bindings/display/panel/display-timing.txt.
 
 
 Connectivity

Documentation/devicetree/bindings/dma/renesas,rcar-dmac.txt

@@ -25,6 +25,7 @@ Required Properties:
 		- "renesas,dmac-r8a7794" (R-Car E2)
 		- "renesas,dmac-r8a7795" (R-Car H3)
 		- "renesas,dmac-r8a7796" (R-Car M3-W)
+		- "renesas,dmac-r8a77965" (R-Car M3-N)
 		- "renesas,dmac-r8a77970" (R-Car V3M)
 
 - reg: base address and length of the registers block for the DMAC

Documentation/devicetree/bindings/net/renesas,ravb.txt

@@ -17,6 +17,7 @@ Required properties:
 
       - "renesas,etheravb-r8a7795" for the R8A7795 SoC.
       - "renesas,etheravb-r8a7796" for the R8A7796 SoC.
+      - "renesas,etheravb-r8a77965" for the R8A77965 SoC.
       - "renesas,etheravb-r8a77970" for the R8A77970 SoC.
       - "renesas,etheravb-r8a77980" for the R8A77980 SoC.
       - "renesas,etheravb-r8a77995" for the R8A77995 SoC.

Documentation/devicetree/bindings/pinctrl/allwinner,sunxi-pinctrl.txt

@@ -55,9 +55,9 @@ pins it needs, and how they should be configured, with regard to muxer
 configuration, drive strength and pullups. If one of these options is
 not set, its actual value will be unspecified.
 
-This driver supports the generic pin multiplexing and configuration
-bindings. For details on each properties, you can refer to
-./pinctrl-bindings.txt.
+Allwinner A1X Pin Controller supports the generic pin multiplexing and
+configuration bindings. For details on each properties, you can refer to
+ ./pinctrl-bindings.txt.
 
 Required sub-node properties:
   - pins

Documentation/devicetree/bindings/serial/amlogic,meson-uart.txt

@@ -21,7 +21,7 @@ Required properties:
 - interrupts : identifier to the device interrupt
 - clocks : a list of phandle + clock-specifier pairs, one for each
 	   entry in clock names.
-- clocks-names :
+- clock-names :
    * "xtal" for external xtal clock identifier
    * "pclk" for the bus core clock, either the clk81 clock or the gate clock
    * "baud" for the source of the baudrate generator, can be either the xtal

Documentation/devicetree/bindings/serial/mvebu-uart.txt

@@ -24,7 +24,7 @@ Required properties:
     - Must contain two elements for the extended variant of the IP
       (marvell,armada-3700-uart-ext): "uart-tx" and "uart-rx",
       respectively the UART TX interrupt and the UART RX interrupt. A
-      corresponding interrupts-names property must be defined.
+      corresponding interrupt-names property must be defined.
     - For backward compatibility reasons, a single element interrupts
       property is also supported for the standard variant of the IP,
       containing only the UART sum interrupt. This form is deprecated

Documentation/devicetree/bindings/serial/renesas,sci-serial.txt

@@ -41,6 +41,8 @@ Required properties:
     - "renesas,hscif-r8a7795" for R8A7795 (R-Car H3) HSCIF compatible UART.
     - "renesas,scif-r8a7796" for R8A7796 (R-Car M3-W) SCIF compatible UART.
     - "renesas,hscif-r8a7796" for R8A7796 (R-Car M3-W) HSCIF compatible UART.
+    - "renesas,scif-r8a77965" for R8A77965 (R-Car M3-N) SCIF compatible UART.
+    - "renesas,hscif-r8a77965" for R8A77965 (R-Car M3-N) HSCIF compatible UART.
     - "renesas,scif-r8a77970" for R8A77970 (R-Car V3M) SCIF compatible UART.
     - "renesas,hscif-r8a77970" for R8A77970 (R-Car V3M) HSCIF compatible UART.
     - "renesas,scif-r8a77995" for R8A77995 (R-Car D3) SCIF compatible UART.

Documentation/devicetree/bindings/vendor-prefixes.txt

@@ -181,6 +181,7 @@ karo	Ka-Ro electronics GmbH
 keithkoep	Keith & Koep GmbH
 keymile	Keymile GmbH
 khadas	Khadas
+kiebackpeter    Kieback & Peter GmbH
 kinetic Kinetic Technologies
 kingnovel	Kingnovel Technology Co., Ltd.
 kosagi	Sutajio Ko-Usagi PTE Ltd.

Makefile

@@ -1,7 +1,7 @@
 # SPDX-License-Identifier: GPL-2.0
 VERSION = 4
 PATCHLEVEL = 16
-SUBLEVEL = 15
+SUBLEVEL = 18
 EXTRAVERSION =
 NAME = Fearless Coyote