What causes left side to be double image and right side of photo is ok.

[Moikka2]

Please see photo of problem, the star is double for the first 3 and 2 are ok. this is constant.

• changed starting position but no effect.
• changed to slow speed / slow buffer / slow linear speed -> no effect.

What could be the problem
(Laser = Sculpfun s9) (Laser GRBL 5.7.0)
To my undertsanding this started when 5.7 was installed.

and secondary question. always this has happened but so small -> the most left side has always lost the top spike part (when the picture is ok, it also looses then)

Any advice what to test?

[Moikka2]

Update. reverted back to 5.6.0 and all ok. so this is 5.7 bug? (how to report official bug?)

[arkypita]

Nothing has changed between 5.6 and 5.7 that can cause your issue.
I suggest you do some further testing before claiming otherwise.

In my opinion the problem must be looked for elsewhere.

[Moikka2]

HiYes this is odd because tested all wires. The belts etc. Cleaned nozzle. Nothing else helped than reverting to old. Might there be setting change between versions?Sent from Android deviceOn 9 Jan 2024 19.18, arkypita ***@***.***> wrote: Nothing has changed between 5.6 and 5.7 that can cause your issue. I suggest you do some further testing before claiming otherwise. In my opinion the problem must be looked for elsewhere. —Reply to this email directly, view it on GitHub, or unsubscribe.You are receiving this because you authored the thread.Message ID: ***@***.***>