You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
In the overview "Itho Status" there is an ID "FanInfo" this gives the human readable translation of ID "Selection".
Overview of observed values in my Itho CVE-S HE Optima 2 box.
Selection FanInfo
2 low
3 medium
4 high
5 timer3
7 auto
8 unknown
"Unknown" for "selection" = 8 should probably be "autonight"
"timer3" would probably be better named "timer" as it is used for timer1, timer2, timer3. The difference between these 3 timers is visible in de ID "RemainingTime(min)".
The "auto night" option can be selected with RFT-CO2 (fast blinking Auto LED) or by pressing the "auto" button on RFT-Auto remote 2x quickly.
tested on HW + SW NRG-Watch PCB
Current firmware version: 2.8.0
Hardware revision: 2
The text was updated successfully, but these errors were encountered:
Autonight seems to be the value 0x19, it was added with commit: da2fc90 and will be part of the next version.
which doesn't mean that 0x08 isn't also autonight but I haven't seen it before. Is there a way to confirm this?
"timer3" would probably be better named "timer" as it is used for timer1, timer2, timer3. The difference between these 3 timers is visible in de ID "RemainingTime(min)".
On CVE devices it seems that this is always timer3 indeed. Not sure about other itho devices though.
It can be changed of course but it's only cosmetical and might break some integrations. For now I'm leaving it as it is.
edit:
Looking at your list again the numerical values do not seem to match the observed values for the FanInfo data. Where did you get the values numbers from?
Above you see a screenshot of Itho Status overview, where I have selected Autonight mode on Itho Optima 2 box.
Label FanInfo is the first line in the screenshot, Label Selection i the bottom/last line.
On screenshot below you see the same info when Auto mode is selected. I assume you "translate" the number in Selection to a human readable format in FanInfo. In case you read FanInfo directly from the box, and not "translate" it is seems a small bug in the Itho box.
In the overview "Itho Status" there is an ID "FanInfo" this gives the human readable translation of ID "Selection".
Overview of observed values in my Itho CVE-S HE Optima 2 box.
Selection FanInfo
2 low
3 medium
4 high
5 timer3
7 auto
8 unknown
"Unknown" for "selection" = 8 should probably be "autonight"
"timer3" would probably be better named "timer" as it is used for timer1, timer2, timer3. The difference between these 3 timers is visible in de ID "RemainingTime(min)".
The "auto night" option can be selected with RFT-CO2 (fast blinking Auto LED) or by pressing the "auto" button on RFT-Auto remote 2x quickly.
tested on HW + SW NRG-Watch PCB
Current firmware version: 2.8.0
Hardware revision: 2
The text was updated successfully, but these errors were encountered: