You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
Great project, I can't wait to get it working on my 2020 Kossel. I've set everything up according to the settings described in the configuration.h file, but when my printer is going through the G30 command, it drags the Z-probe (Spring Loaded allen key) on the bed. Where can I add the z_raise_between_probing setting so that doesn't happen?
Thank you,
Robert
The text was updated successfully, but these errors were encountered:
I had the same problem, I saw this parameter and I changed it but now I don't remember. Later I'll see the font program and I'll send you the parameter and the line that you can modify.
I solved this problem by changing Z_MIN_ENDSTOP_INVERTING constant in Configuaration.h. You can check this by issuing M119 command - it should read "open" when probe is not touching the bed. Hope this helps!
Hi,
Great project, I can't wait to get it working on my 2020 Kossel. I've set everything up according to the settings described in the configuration.h file, but when my printer is going through the G30 command, it drags the Z-probe (Spring Loaded allen key) on the bed. Where can I add the z_raise_between_probing setting so that doesn't happen?
Thank you,
Robert
The text was updated successfully, but these errors were encountered: