Board: STMicroelectronics NUCLEO-F429ZI
Device: STM32F429ZIT6
System Core Clock: 168 MHz
This setup is configured using STM32CubeMX, an interactive tool provided by STMicroelectronics for device configuration. Refer to "Configure STM32 Devices with CubeMX" for additional information.
| System resource | Setting |
|---|---|
| Heap | 64 kB (configured in the STM32CubeMX) |
| Stack (MSP) | 1 kB (configured in the STM32CubeMX) |
STDIO is routed to Virtual COM port on the ST-LINK (using USART3 peripheral)
| CMSIS-Driver | Peripheral | Board connector/component | Connection |
|---|---|---|---|
| Driver_ETH_MAC0 | ETH | Ethernet RJ45 connector (CN14) | CMSIS_ETH |
| Driver_ETH_PHY0 | LAN8742A (external) | Ethernet RJ45 connector (CN14) | CMSIS_ETH |
| Driver_GPIO0 | GPIO | Arduino digital I/O pins D2..D10, D14..D19 | ARDUINO_UNO_D2..D10, D14..D19 |
| Driver_I2C1 | I2C1 | Arduino I2C pins D20..D21 | ARDUINO_UNO_I2C |
| Driver_USART2 | USART2 | ZIO pins D52..D53 (CN9) | CMSIS_USART |
| Driver_USART3 | USART3 | ST-LINK connector (CN1) | STDIN, STDOUT, STDERR |
| Driver_USART6 | USART6 | Arduino UART pins D0..D1 | ARDUINO_UNO_UART |
| Driver_USBD0 | USB_OTG_FS | User USB connector (CN13) | CMSIS_USB_Device |
| CMSIS-Driver VIO | GPIO | LEDs (LD3, LD1, LD2) and USER button (B1) | CMSIS_VIO |
Note: D11 (SPI_COPI) pin on Arduino Connector is unavailable, because it is used by the Ethernet configuration.
Reference to Arduino UNO connector description.
| CMSIS-Driver VIO | Board component |
|---|---|
| vioBUTTON0 | USER button (B1) |
| vioLED0 | LED red (LD3) |
| vioLED1 | LED green (LD1) |
| vioLED2 | LED blue (LD2) |