Skip to content

Latest commit

 

History

History
66 lines (45 loc) · 2.34 KB

AHT1x.md

File metadata and controls

66 lines (45 loc) · 2.34 KB

AHT10/AHT15 temperature and humidity sensor

??? failure "This feature is not included in precompiled binaries"

When [compiling your build](Compile-your-build) add the following to `user_config_override.h`:
```c++
#ifndef USE_AHT1x
#define USE_AHT1x       // [I2cDriver43] Enable AHT10/15 humidity and temperature sensor (I2C address 0x38, 0x39) (+0k8 code)
#endif
```

AHT1x are an I2C temperature and humidity sensor. AHT2x or AM2301B are upgraded versions.

Configuration

!!! failure "This sensor is incompatible with other I^2^C devices on I^2^C bus" Sensor datasheet implicitly says: Only a single AHT10 can be connected to the I^2^C bus and no other I^2^C devices can be connected. The AHT2x/AM2301B does not suffer from this problem.

Wiring

AHT ESP
VCC 3.3V
GND GND
SDA GPIOx
SCL GPIOy

Tasmota Settings

In the Configuration -> Configure Module page assign:

  1. GPIOx to I2C SDA
  2. GPIOy to I2C SCL

After a reboot the driver will detect AHT1x automatically and display sensor readings.

webUI readout

and in MQTT topic (according to TelePeriod):

{"Time":"2020-01-01T00:00:00","AHT1X-0x38":{"Temperature":24.7,"Humidity":61.9,"DewPoint":16.8},"TempUnit":"C"}

Troubleshooting

On some I2C sensors, like the AHT25, Tasmota might mistake the sensor for another one using the same address. This can be resolved by disabling the unneeded drivers.

For our example AHT25, the address might get confused with the VEML6070 UV sensor. You can tell Tasmota to use the other driver by issuing the following commands in the console:

  • I2CDriver12 0 to disable the VEML driver
  • I2CDriver43 1 to enable the AHT driver

An overview of all I2C drivers is available in the docs.

Breakout Boards

AHT10AHT15

Note: The pins on the smaller breakout board with the AHT15 are in a different order: VDD - SDA - GND - SCL See also the datasheet.

AHT10 Datasheet
AHT15 Datasheet