DC Grid Feed IN and DVCC

[peregrines2]

Hi!

I just found out why I am always running into BMS Emergency-Turn offs and my MPPTs dont stop charging my batteries even after reaching my SOC High Limits.
Enabling DC Grid Feed in dissables DVCC settings for cell voltages.

How do you guys handle that? I need to DC-Feed to the grid when my batteries are "full" because I dont want to loose a big amount of energy with my two MPPT 450/100.

Is there any "workaround" to export excess energy to the grid and stop charing my batteries with DC Feed in turned ON?
I am using Homeassistant and have Modbus and MQTT Setup - maybe there is some way to program something as a automation?

[redmoon2711]

Hi,

you can try to set CVL (Charge Voltage Limit) to Float_Voltage (3.35V per cell) when the battery is full.

This will stop the charging process and the current flows from MPPT into grid.

[peregrines2]

Thank You for your answer @redmoon2711 (I just rediscovered it).

I set everything according to your suggestions (CVCM_ENABLE = True, Cell Max is 3,45V and float is 3.35V)
As soon as the batteries reach CVL ( 55,2V) both MPPT limited their production to zero.
My AC inverters keep producing and the Multiplus export their exccess energy to grid ... just my MPPT stop completely :(
Do you have any other settings I could check?
What Cell max and float Values should I set for my MPPT in Victron Connect and what values for my Multiplus in Ve.Config?
I would be extremely happy to sort this out and be able to export to grid again!!
Thank You so much @redmoon2711 !

[snow78]

which version of driver are you using. i use 1.0.20240102beta. have as similar setup as yours, and it works.
you have step mode active. you should use LINEAR_LIMITATION_ENABLE = True in config.ini
this will gracefully ramp down from full charge voltage to float
you can see in your picture that the CVL is still 55.2 which is in a 16 cell LIFEPO4 to much for a float. your cells will be likely overcharged
LINEAR_LIMITATION_ENABLE = True has also advantage that it prevents single cell overvoltage when you have inbalanced packs. it will reduce the overall charge voltage
but why its not feeding to grid i dont know. setting is turned on? you do not use aggregatebatteries by any chance?

[peregrines2]

Thank You snow78!

I updated to the newest beta and set CVCM_ENABLE = True
Every since it is working.
I also set LINEAR_LIMITATION_ENABLE = True for smoother ramping.

[Ray356]

@peregrines2,

how do you handle that with the mppt's?
If i turn on "DC Grid Feed in" my mppts don't care about he maximum charge current which is coming from the driver.

[snow78]

@Ray356 this is normal that is general behaves as designed in the VENUS. this is not an issue of the serial driver. i have the same. when DC Grid feed in is active it will "ignore" the max currect from the BMS signaled. the logic i understand behind it ... to have Grid feed in possible the MPPTs are basically not limited... but then the Batteries will surge as much current as they can get and only what the batteries do not take is feed by the e.g Multiplus to grid. limiting of charge current is bassically only possible via charge voltage limitation which kicks in with serial driver when e.g. cell overvoltage is detected. the way i solved it is by having a large enough battery (i have 3 banks with 16s *280ah) so that mppts never can exceed the max charge current.