You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
Is there any way to test the mesh? (i.e. just run through the mesh and ensure that it's still good, and adjust it if needed?) I find it would be faster to run through the mesh points and adjust, than to start from scratch and re-create the mesh every time the printer is moved (as, while the bed might shift a bit, it wouldn't shift a LOT... only a few millimetres.) I would be good to be able to just run through the mesh points just to check them.
reacted with thumbs up emoji reacted with thumbs down emoji reacted with laugh emoji reacted with hooray emoji reacted with confused emoji reacted with heart emoji reacted with rocket emoji reacted with eyes emoji
-
Is there any way to test the mesh? (i.e. just run through the mesh and ensure that it's still good, and adjust it if needed?) I find it would be faster to run through the mesh points and adjust, than to start from scratch and re-create the mesh every time the printer is moved (as, while the bed might shift a bit, it wouldn't shift a LOT... only a few millimetres.) I would be good to be able to just run through the mesh points just to check them.
Beta Was this translation helpful? Give feedback.
All reactions