The ENSABrew-100A is an electronic device for automation in the craft beer brewing process! Based on the ATmega 2561 microcontroller, it includes analog inputs (NTC), digital inputs (water level and volume control) and modulated outputs (PWM/SSR). Connection via Wi-Fi or Bluetooth app. All these facilities in a single product.
This project is based on the excellent project: 👍 @MCUdude/MegaCore
This installation method requires Arduino IDE version 1.6.4 or greater;
- Open the Arduino IDE;
- Open the File > Preferences menu item;
- Enter the following URL in Additional Boards Manager URLs:
https://mcudude.github.io/MegaCore/package_MCUdude_MegaCore_index.json - Open the Tools > Board > Boards Manager... menu item;
- Wait for the platform indexes to finish downloading;
- Scroll down until you see the MegaCore entry and click on it;
- Click Install (version 2.1.1);
- After installation is complete close the Boards Manager window.
Ok, so you're downloaded and installed MegaCore, but how to get started? Here's a quick start guide:
- Hook up your microcontroller as shown in the pinout diagram;
- If you're not planning to use the bootloader (uploading code using a USB to serial adapter), the FTDI header and the 100 nF capacitor on the reset pin can be omitted;
- Open the Tools > Board menu item, select MegaCore and select our preferred target;
- Select your preferred clock frequency. 16 MHz is standard on most Arduino boards;
- Select what kind of programmer you're using under the Programmers menu;
- Hit Burn Bootloader. If an LED is connected to pin PB5/PB7, it should flash twice every second;
- Now that the correct fuse settings is sat and the bootloader burnt, you can upload your code in two ways:
- Disconnect your programmer tool, and connect a USB to serial adapter to the microcontroller, like shown in the pinout diagram. Then select the correct serial port under the Tools menu, and click the Upload button. If you're getting some kind of timeout error, it means your RX and TX pins are swapped, or your auto reset circuity isn't working properly (the 100 nF capacitor on the reset line).
- Keep your programmer connected, and hold down the
shiftbutton while clicking Upload. This will erase the bootloader and upload your code using the programmer tool.
Your code should now be running on the microcontroller!
Since there are no standardized Arduino pinout for this chip family, MCUdude created one tried to make it as simple and logical as possible. The standard LED pin is assigned to Arduino pin 13 (PB5), is available on the expansion terminal, pin 26, and will blink twice if you hit the reset button.
Select your microcontroller in the boards menu, then select the clock frequency. You'll have to hit Burn bootloader in order to set the correct fuses and upload the correct bootloader. Make sure you connect an ISP programmer, and select the correct one in the Programmers menu. For time critical operations an external oscillator is recommended.