diff --git a/instructions.md b/instructions.md index cce1c08..9f0feff 100644 --- a/instructions.md +++ b/instructions.md @@ -36,7 +36,7 @@ The probe is built from components of other projects. The original part of this | Install the other two swing arm screws | ![Alt text](images/probe_attach_arms2.png) | | Solder the probe wires to the bottom of the PCB Klicky lower PCB. One in the front, one at the back. Middle hole stays empty | ![Alt text](images/probe_solder_wires.png) | | Install the magnets that live under the PCB. The rear one should attract to the dock, the other should repel the lower swing arm. You may need to swap between N35 and N52 magnets to get just enough spring force to activate the swing arm. Too much won't let the arm move and will push the klicky PCB magnets apart. | ![Alt text](images/probe_rear_body_magnets.png) | -| Install the Klicky PCB magnets with the counter sunk screws. Get your polarity right. | ![Alt text](probe_install_pcb_magnets.png) | +| Install the Klicky PCB magnets with the counter sunk screws. Get your polarity right. | ![Alt text](images/probe_install_pcb_magnets.png) | @@ -70,4 +70,4 @@ Like the rest of Klicky-00, magnets are used as "springs" because they're magic. | Thread the height adjustment screw into the height adjuster and clip it into place | ![Alt text](images/bump_dock_height_adj.png) | | Attach the Klicky dock to the bump dock. Don't forget the magnet and it's polarity if you have existing probes | ![Alt text](images/bump_dock_klicky-dock.png) | | Install Magnets to be the "springs" and "latch"

Depending on how strong your magnets are, and how well everything moves, you may only need these magnets on one side. The top three magnets are setup to push the upper arm forward and the lower two magnets attract to pull the lower part backwards. | ![Alt text](images/bump_dock_springs.png) | -| Time to install it into the printer. | ![Alt text](images/bump_dock_into_printer.png) | \ No newline at end of file +| Time to install it into the printer. | ![Alt text](images/bump_dock_into_printer.png) |