[BUG] load/unload from screen does not operate properly

[lifendel]

Did you test the latest extui code or prerelease?

Yes, and the problem still exists.

Bug Description

If I download and compile the latest firmware from the github, if I select load, the printer heats to 200°, moves the gantry up and then right back down without moving the extruder. If I select unload, it heats to 200°, moves the gantry up, unloads the filament maybe 10mm, then immediately feeds 10+mm as it starts extruding and then the extruder skips as it is extruding too fast (it's only brief, so maybe 15-20mm) stops and lowers the gantry back down. If I download and compile the 6.1 tagged source and install that, load/unload works properly. This happens on both the SE and Max.

Bug Timeline

No response

Expected behavior

No response

Actual behavior

No response

Steps to Reproduce

No response

Version of CR6Community Firmware

6.2

Printer model

Creality CR-6 MAX

Motherboard

Creality v4.5.3

Display

Creality CR-6 stock touch screen

Mods

No response

Add-ons

No response

Bed Leveling

No response

Your Slicer

No response

Host Software

No response

[G00364778]

I have the same issue.

Version of CR6Community Firmware: 6.2
Printer model: Creality CR-6 SE
Motherboard: Creality v4.5.3
Display: Creality CR-6 stock touch screen

• Filament load/unload does not move at all.
• Extrusion calibration does not move either

[Thinkersbluff]

There is no formal release 6.2 of the Community Firmware. Yes, if you download the latest Code from the repo, it has this issue. The last stable release was/is 6.1.